Cisco CCNA / CCNP Certification Exam: Same Command, Different Results

September 25th, 2022 by admin Leave a reply »

As a CCNA or CCNP,Guest Posting one thing you’ve got to get used to is that change is constant. Cisco regularly issues new IOS versions, not to mention the many different kinds of hardware they produce! While it’s always nice to have “the latest and the greatest” when it comes to routers, switches, firewalls, etc., we have to be prepared for the fact that not all our clients are going to have that latest and greatest!

For instance, there are still quite a few Catalyst 5000 switches out there humming away, and if you’re used to working on IOS-driven switches like the 2950, the same command can have dramatically different results.

Let’s say you’re going to examine the spanning tree protocol (STP) setup of a new client. You’re used to working with newer 2950 switches, and you’ve always run show span on those switches to display spanning-tree information. Then, you run show span on a Catalyst 5000 – and something like this shows:

switch (enable) show span

Destination : Port 6/1

Admin Source : Port 6/2

Oper Source : Port 6/2

Direction : transmit/receive

Incoming Packets: disabled

Learning : enabled

Multicast : enabled

Filter : -

Status : active

Total local span sessions: 1

What’s going on here?

The command show span on a 5000 will not show spanning tree stats – instead, what you’re going to see are statistics relating to Switched Port ANalyzer (SPAN). Surprise!

Consider an example where you’re used to running show span on 5000 switches to see SPAN information. When you run that on a 2950, you know now what you’re going to get – spanning tree information! To get SPAN stats on a 2950, you’ll need to run show monitor session, followed by the SPAN session number.

Advertisement

Comments are closed.